Runs in the clear
/Hey Sully. I need to ask you some advice. I bought an old Washburn electric guitar about a month ago and sanded it down, sprayed the wood primer, two cans of color and now I'm busy spraying the clear coat. I placed the first can in a bit of warm water like on your one video and then started to spray. There are 3 places on the guitar where the paint started to run. Also the finish feels a bit rough like 1200 grit sand paper which I think is because I'm holding the spray can too far away.
Would I be able to sand out the 3 paint runs? I've finished the first can of clear paint and I have another can.
If you’re shooting lacquer from a spray can, don’t worry about the clear coat runs just yet; keep shooting the clear. The lacquer will melt into each other, and you can level sand it out when you’ve got all your clear on there. If it’s rough in certain areas, yes, you’re most likely too far away and the clear is drying in the air before it hits the body. Also, when it comes to using spray cans, use about 2/3 of them; the last bit is mostly solvent, and they’ll tend to spit and sputter when you’re running low.